As rule, slider position altering gives minimal effect. FLAC compressing slider: set several compression levels.If the target resolution is 24 bit and more (including float point), the Dither button is ignored. Other modes are implemented as linear only.ĭithering is applied to extracting to 16-bit output resolution only. Use minimum phase filter switch checked/unchecked minimum/linear phase filtering in "Optimized." mode.
Therefore " Optimized." mode is recommended as the first choice. "Non-Optimized wide resampling filter" suppress signal upper 20.100 kHz (defined by input/output sample rates) so that provide a wider band of a musical signal.Īt some equipment software " Non-Optimized." modes can cause audible noise, like in this video. " Non-Optimized resampling filter" suppress signal upper 20.24 kHz (defined by input/output sample rates) - ultrasound eliminating so that remove intermodulation distortions, wider signal band "Optimized resampling filter" removes frequency range upper 20 kHz (ultrasound eliminating so that remove intermodulation distortions) Downsampling processing based on filtering with varying settings.Īt Settings > General tab > set Filter mode: Read details about music conversion and sound quality issues.Įxtraction into PCM format applies the downsampling. But it doesn't guarantee, that you get the best result. In general, you can convert to file in the maximal sample rate and bit depth of your DAC. It is bound with different playback modes for combinations "bit depth + sample rate". These lines show audible distortions, that correlate with the original signal.īit depth and sample rate of converted files may give different playback quality to your system. In the ideal case, should not be repeatable lines with lower brightness. Third-party utility decode SACD ISO for additional processing with AuI ConverteR. WARNING: AuI ConverteR 48x44 doesn't support DVD-audio and DVD-video.ĪuI ConverteR process too long file names and paths, non-Latin and forbidden characters (created from metadata) for successful output file writing. In Settings > General > "Output attenuator" field, set "-3 dB" or "-6 dB" or use peak level normalization** to achieve maximal loudness. If you got audible artefacts and distortions, it is rather overload issue. (Converted (ripped) stuff is placed in the target directory)
(watch video, read manual)Īt the main window > Album art tab assign album artwork file. (for higher resolutions Dither button will be ignored) When target bit depth is 16 bit, dithering ON is recommended. Select target FLAC format at the main window Format panel.
0 kommentar(er)
